Are computer stands no longer available or do they call them something different? I am going to sound old, but in my day, computer stands are what we set computers on when we put them on the floor. Why? Not only does it provide better air flow (for power supplies with down-facing fans) but it also lessens the dust build up. You should still dust your computer at least once a year if you are setting it on the floor.
I tried looking for “computer stand” and all I get are standing desk and laptop/monitor stands. If you scroll through pages, I eventually find what I am looking for, but not many.
I gave up. I figured I’ll just make my own. I don’t need anything fancy. I just need something to lift the tower off the floor a few inches. I took a 2″x4″ piece of wood and cut it 12″ in length. I then used MDF (medium density fiberboard) and cut it to 12″x24″. The 24″ length is based on the case I have which is a a Fractal Design Define R4 case. It is 20.5″ in length.
I sanded the pieces just to smooth the surface. I haven’t decided whether I will paint it or not. I took 3 pieces of the 2×4 and lined them up on the edges and the center for support.
I applied wood glue to secure the legs. That way when I predrill, the legs won’t move around. I don’t have a table or clamps to keep them in place. This step isn’t necessary if you can keep the legs in place.
I predrilled 3 holes per leg. I just used #8 screws at 1 3/4″. Be careful when buying screws. Pay attention to the head. I picked ones with a double-square (star-shaped) head rather than a Phillips (+) head. Luckily, I had a torx bit that works.
Be careful when driving in the screws with power tools. MDF is pretty weak and you can easily drive in the screw below the surface of the MDF plywood. Below are some photos of the finished stand.
This stand lifts the computer off the floor by 4.5″. If you want to go higher, use 2″x6″ studs instead. But depending on the length of the plywood, I would probably do 4 legs instead of 3.
You can also run cables or wires between the legs. There’s also room on the sides of the plywood to run cables. I like using these cable clips. It has a pretty strong adhesive if you want to mount them on surfaces.
Leave a Reply